28
Lap/Shoulder Belt with Locking Latch Plate
The lap portion of this belt does not loosen once the belt is
buckled.
The vehicle belt is tightened by pulling up hard on shoulder belt
and feeding the extra webbing into the retractor.
Lap/Shoulder Belt with Sliding Latch Plate with Locking Retractor
The latch plate slides freely along the lap/shoulder belt. Vehicle
belts with sliding latch plates are typically locked at the shoulder
belt retractor by buckling the belt and pulling all of the webbing
out slowly to switch the retractor.
Check vehicle owner’s manual for specic instructions. The vehicle belt is
tightened after switching the retractor by pulling up on shoulder belt and feeding
the webbing into the retractor.
!
WARNING! DEATH or SERIOUS INJURY can occur.
Seat Belt Warnings
To Next Page
Loading...
