63
Lap/Shoulder Belt (Rear-Facing and Forward-Facing)
Installing Lap/Shoulder Belt (Preferred Method)
Base should not move more than
2.5 cm (1 in) side to side or front
to back at the Belt Path on the Car
Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
vehicle belt a little more, and try
again. If Base still moves too much,
you may need to try a different
vehicle seat location, installation
method, or both.
11. Lock the seat belt. In most
vehicles, you can switch your
shoulder belt retractor into locking
mode by pulling shoulder belt all
the way out and letting it rewind
into the retractor. Pull on shoulder
belt to make sure it is locking.
To Next Page
Loading...
