83
LATCH/UAS (Rear-Facing and Forward-Facing)
Installing LATCH/UAS
12. Grab Base near belt path as
shown and pull side to side and
front to back to make sure Base is
installed tightly. Base should not
move more than 2.5 cm (1 in) side
to side or front to back at the Belt
Path on the Car Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
LATCH/UAS strap a little more,
and try again. If Base still moves
too much, you may need to try
a different vehicle seat location,
installation method, or both.
To Next Page
Loading...
