94
Booster Mode (Forward-Facing Only)
Installing the Booster
4. Remove Tether from Tether Storage
Location under the Base and place
the Base in an approved rear vehicle
seating location. Make sure the
Base lies at on the vehicle seat and
rmly up against the seat back.
3. Remove LATCH/UAS anchors from
storage locations on back side of
base. Remove each connector by
pulling out on red release strap.
IMPORTANT: You may use the Tether Strap and Lower Anchor Connectors to
secure this booster seat to the vehicle seat as long as the position of the booster
seat in the vehicle and/or the resulting t of the vehicle seat belt over the child are
not affected.
To Next Page
Loading...
