3
WARNING
ASSEMBLING YOUR STROLLER
1
Turn the stroller upside down, as shown, so the rear of the
stroller is facing upwards.
To attach rear wheels, push wheel onto rear leg tube until it clicks
into place. Repeat on other side.
PULL ON wheels to make sure both of them are securely attached.
Remove and IMMEDIATELY
discard the zip tie around footrest.
Care must be taken when folding or unfolding
stroller to prevent finger injury in hinge areas.
To protect flooring, place a protective covering
(cardboard, towel, small rug or blanket) beneath
the stroller during assembly.
Grab the parent’s handle
B
near the top of the canopy
and pull upward until the stroller opens fully with an
audible click. Make sure the stroller locks in the open
position by pushing down on the parent’s handle.
Unlatch side frame lock
A
.
Continue holding the lock open
while unfolding the stroller.
A
CLICK!
B
2
CLICK!
C
C
To remove, push metal button
and pull wheel o stroller.
To Next Page
Loading...
