27
26
Adjust the child restraint to
the upright position
(page 36). Place the child
restraint in your vehicle
forward-facing.
If the vehicle belts are not
routed and fastened correctly,
the child restraint may not
protect your child in a crash.
WARNING
Installing Your Child Restraint
Forward-facing Using a Seat Belt
DO NOT use the three lower harness slots
forward-facing. The harness may not properly
restrain the child in the event of a crash.
1
B
A
2
3
WARNING
Make sure that the harness
straps are in one of the three
upper strap slots
A
and
the splitter plate is attached
to the bottom of the harness
strap in the toddler position
B
(page 35). This will provide
more room for your toddler to
fit comfortably.
C
A
Thread the vehicle seat
belt
C
through the
forward-facing belt path
behind the seat pad.
Note: Lift seat pad away
from seat for easier access.
Lap Belt Only Lap & Shoulder Belt
4
5
Remove Locking Clip from vehicle seat belt when not used
with a child restraint, or the vehicle seat belt will not properly
restrain an adult or child. Serious injury could occur.
WARNING
Fasten the vehicle seat belt as shown depending on
your type of seat belt.
Note: Install locking clip on lap and shoulder belt
combinations, if necessary.
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
Consult your vehicle owner’s manual before
installing a locking clip.
If your vehicle requires a Locking Clip, please call
ParentLink at 1-800-233-5921 (U.S.) or 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) to obtain a
Locking Clip and instructions on how to install and use
it.
Install Locking Clip
(not included), if
necessary.
If your vehicle was built prior
to model year 1996, and
has a lap/shoulder belt that is
equipped with an emergency
locking retractor (ELR) AND
sliding latch plate, you MUST
use a Locking Clip. Check
your vehicle owner’s manual
to identify which vehicle belt
system is in your vehicle.
Locking Clip
installed properly
13 mm
(0.5 inch)
To Next Page
Loading...
