33
32
4
3
C
• To avoid a strangulation hazard, you MUST tightly roll or
fold excess tether strap and secure with the strap/rubber
band.
• Attach the tether hook to the storage clip when not in use.
This will keep an unused tether from hitting someone during
a crash.
WARNING
5
WARNING
• Failure to follow these instructions could result in
serious injury to your child or other vehicle occupants.
• The tether strap is for forward-facing use only.
After adjusting the top tether strap, you may have
excess strap; DO NOT cut it off. If you do, it may not be
long enough to use in another vehicle. Instead, tightly
roll up the excess tether strap and place the
rubber band around the bundle.
Note: Refer to your vehicle owner’s manual for the
location of the tether anchor bracket in your vehicle.
Older vehicles may not come equipped with anchor
bracket hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors that are
not addressed by the vehicle owner’s manual or
answered by an authorized dealer/vehicle manufac-
turer, call Evenflo’s ParentLink at 1-800-233-5921 (U.S.)
or 1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
F
G
H
Hook
Adjuster
Strap
SecureRight Quick Connector
Clip
Strap
Adjuster
J
J
K
J
L
Ö
Know Your Lower Anchor
Connector Assembly
The lower anchor connector assembly that comes with
your child restraint will be one of the two types below.
Refer to your vehicle owner’s manual to locate the lower
anchor bars
J
on your vehicle seat.
Attach the right hook
K
, or clip
L
, to the right anchor bar
J
and the left hook,
or clip, to the left anchor bar.
DOUBLE CHECK that the
lower anchor connector hook is fully engaged by pulling
hard on the lower anchor connector strap.
DO NOT use this child restraint if it moves more than 25 mm (1 in.)
side-to-side or front to back at the forward-facing belt path. Serious
injury or death may result from poor installation. If you can not tightly
secure the child restraint, try again, move it to another location, or
install with the vehicle seat belt.
WARNING
Using your full weight, push the child restraint firmly
into the vehicle seat, while pulling up on the
lower anchor
connector
strap to tighten.
The lower anchor connector strap must be as tight as
possible. If you can move the child restraint more than 25
mm (1 in.) side to side or front to back at the belt path
C
,
the
lower anchor connector
strap is not tight enough. You
will need to try again, find another location for your child
restraint, or install with the vehicle seat belt (page 26).
To
remove the
lower anchor connector
strap
, go to page 44.
Connect the tether
hook
F
to the vehicle
tether anchor
G
behind
the vehicle seat, as
shown. (Please consult
your vehicle owner’s
manual, as tether anchor
locations may vary.) Pull
the strap
H
and tighten
the tether securely.
To Next Page
Loading...
