Evenflo VIVE - Infant Car Seat Installation

8
USING YOUR STROLLER WITH THE EMBRACE INFANT CAR SEAT
Embrace
C
WARNING
• Only use the Evenflo Embrace infant car seat with this stroller.
Other infant car seats or carriers are not designed to fit the stroller frame and may result in serious injury to your child if
used with this stroller.
• To assure safety for your baby, please refer to the manufacturer’s instructions for the use of your Embrace infant car
seat and keep all instructions available for reference.
• DO NOT lift stroller by using the Embrace infant car seat handle when installed on stroller.
• If unable to securely attach Embrace infant car seat to this stroller, remove the car seat and contact Evenflo
ParentLink at 1-800-233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
• To avoid serious injury to the child, when the Embrace infant car seat is in the stroller, make sure the infant car seat is
securely snapped onto the child’s tray and secured with car seat stabilizer.
• Some Embrace infant car seats have a blanket/boot option that must be removed for proper attachment to this stroller.
1. Fully recline the stroller seat back (page 5).
2. Make sure the child’s tray is securely latched (page 4).
3. The Embrace infant car seat
A
MUST be in the rear-facing position.
Lower the infant car seat down onto the child’s tray
B
and press downward until you hear the lock snap into place.
4. Secure the front of the Embrace infant car seat
A
with the car seat stabilizer
C
.
Lift the car seat stabilizer
C
over the locking channel
D
, as shown.
5. Pull up on the Embrace infant car seat handle to test the lock.
CHECKLIST FOR PROPER INSTALLATION
• Make sure the Embrace infant car seat
A
is in the rear-facing position.
• Make sure the Embrace infant car seat is securely locked onto the child’s
tray
B
and secured with car seat stabilizer
C
.
• Pull up on the Embrace infant car seat to test that it is properly locked into
place.
B
A
D
D
C