To Next PageTo Next Page
Need help?Do you have a question about the Event electronics 20/20 and is the answer not in the manual?
General| Tweeter Size | 1 inch |
|---|---|
| Tweeter Material | Silk Dome |
| Frequency Response | 38Hz - 20kHz |
| Frequency Response Tolerance | ±3dB |
| Amplifier Power (Total) | 150W |
| Type | Active |
| Woofer Size | 8 inches |
| Woofer Material | Polypropylene |
| Input Impedance | 10 kΩ |
| Input Connectors | XLR, TRS |
| Dimensions (H x W x D) | 10.5 x 11.5 inches |
Adjusts input signal level to match amplifier output; compensates for different input signal levels.
Accepts balanced or unbalanced sources via XLR and 1/4" plugs; details wiring for proper connection.
Shelving filter to adjust low-frequency response below 400Hz for monitoring environment.
Adjusts high-frequency output above 2.6kHz by ±3dB for personal preference.
Turns the unit on and off; indicated by a front-panel LED.
Delivers 100 watts to the companion passive 20/20 monitor; requires correct polarity connection.
Powers the internal 20/20 monitor; refers to internal amplifier section.
Accepts balanced or unbalanced sources via XLR and 1/4" plugs; details wiring for proper connection.
Adjusts input signal level to match amplifier output; compensates for different input signal levels.
Adjusts high-frequency output above 2.3kHz by ±3dB for personal preference.
Adjusts low-frequency response below 400Hz for monitoring environment.
Turns the unit on and off; indicated by a front-panel LED.
Protects against overload or protection conditions; can be reset by pushing the button.
Accepts the detachable linecord for power supply; do not defeat ground connection.
