Event electronics Project Studio PS5 - User Manual

Event Electronics, LLC
P.O. Box 4189
Santa Barbara, CA 93140-4189
Voice: (805) 566-7777
Fax: (805) 566-7771
Web: www.event1.com
E-mail: info@event1.com
Your warranty will be in effect when you send in your warranty card
Event, Event Electronics and PS Project Studio are trademarks of Event Electronics, LLC.
Specifications subject to change without notice
© 1996, 1997, 1998, 1999 Event Electronics, LLC Printed in USA 9/99 1715A
INTRODUCTION …………………….……….………….…………….……
1
UNPACKING ……..……………….…………………………………….… 1
SETUP ………………………………….……………….………………… 1
CONNECTIONS AND
OPERATION
…………………….……….………….…
3
CARE AND
MAINTENANCE
….…………………………………………….…
5
BLOCK DIAGRAMS ….…………………………………………….…
5
SPECIFICATION
S
………………………...…………………………………6
INTRODUCTION Thank you for choosing Event Electronics™ Project
Studio direct field monitors. Before you proceed, please take a minute to read
this manual and familiarize yourself with the product’s features, set-up and use.

Summary

Setup

Speaker Placement

Place monitors at ear level, forming an equal length triangle with the listening position for optimal stereo reproduction.

Connections and Operation

Input Connectors

LINE 1 (1/4" TRS) and LINE 2 (XLR) accept balanced or unbalanced signals for versatile audio input.

Input Sensitivity Control

Adjusts for different signal levels, compensating for amplifier overload with a 20dB range.

Power Switch and Indicator

The power switch controls operation; a green LED indicates when the amplifier power is on.

Specifications

LF Driver

Magnetically shielded mineral filled polypropylene cone with high temperature voice coil and damped rubber surround.

HF Driver

Event electronics Project Studio PS5 Specifications

General

Frequency Response	52Hz - 20kHz
Input Connectors	XLR, TRS, RCA
Crossover Frequency	2.8kHz
Type	Active Studio Monitor
Woofer Size	5.25 inches
Tweeter Size	1 inch
Weight	5.5 kg
HF Driver	1 inch
LF Driver	5.25 inches