Eventide RIPTIDE - System Setup; Entering System Setup; System Configuration Options

1 2 3 4 165 ...
PRESS
VIBE
BUTTON
PRESS
DRIVE
BUTTON
BUFFER
RELAY
DSP+FX
KILL DRY
ON
PRESS
DRIVE
SWITCH
ON
PRESS
VIBE
SWITCH
PRESS
BUTTON
EXP (Default)
EXP + AUX
TRIPLE AUX
MIDI BOX
MIDI TRS
System Setup
Only applies to Pedal Bypass
Factory Default = BUFFER
EXP+AUX
TIP = Expression Pedal
RING = Tap RATE
TRIPLE AUX
TIP = Increment Preset
RING = Decrement Preset
TIP + RING = Load Preset
Note: Times out after a few seconds
MIDI BOX
Receive and Send MIDI via a MIDI
Converter Box (Tip Active)
MIDI TRS
Receive MIDI directly with a DIN
to TRS or TRS cable
Enter System Setup
To access these Global Settings, apply power while holding Drive Footswitch and Swap LED Button. Top two
Preset LEDs are on when in System Setup. Changes are stored as they are made. Cycle power to exit System Setup.
Set MIDI Channel
Set MIDI Clock
Set Bypass Mode
Catch Up ON/OFF
Set EXP Pedal Jack
Set MIDI Channel: Press Vibe LED Button
Factory Default = OMNI
MIDI Clock disables Aux Tap switch and CC 9
Factory Default = O
Factory Default = O