When the battery voltage reaches cut-off value 14.4V/14.7V for 12V battery, 28.8V/29.4V for
24V battery the charge process is terminated, 100% green LED indication lights up. The charge
state of the battery is continuously monitored. When the self-discharge occurs, trickle charge
is reapplied automatically to maintain full charge (it does not affect 100% LED indication).
Notice:
1. In case of a AC power source break / reconnection, the charger will automatically recover,
the regular charge will be applied with a default, maximum current of 2A.
2. In case of a bad battery connection or other fatal error the charger stops operating. The
failure „!” indicator will light up.
3. Regular supervision of charging process is advised.
Using 13.6V DC power supply mode:
1. Do not connect the charger to battery terminals.
2. Connect the charger to AC mains power source. The “Power” LED indicator will light up.
3. Pressing the “MODE” button for 3-5s will activate the 13.6V DC supply mode.
4. This mode can be used for maintenance and float charging of 12V SLA batteries. It will
deliver up to 5A current, with a limited voltage to 13.6V. Can also be used ad DC power supply
for applications not exceeding 4-5A at 13.6V.
5. This mode is suitable to keep the batteries in always-ready condition.
Safety instructions:
1. Read the instructions before using this charger.
2. This charger is intended for use only with 12V/24V batteries - VRLA, AGM, VLA, SLA, WET,
GEL, LEAD ACID. Always check battery's manual for technical specification, charger
recommendation and safety precautions. Attempting to charge other types of batteries may
cause personal injury, damage to the charger or lead to a fire and/or explosion.
3. The charger is intended for indoor use only. Exposure to any liquids or moisture can cause
damage to the charger and battery. Do not allow foreign objects to enter the charger. This
could result in electrical shock or fire.
4. Disconnect the charger from the power socket when not in use.
5. Never use an extension cord or any attachment not recommended by the manufacturer.
6. Do not operate the charger if it has been subjected to shock or damage. Take it to a qualified
serviceman for repair.
7. Do not attempt to disassemble the charger as it may result in a risk of electric shock or fire.
8. Unplug the charger from the power supply before attempting any cleaning. Use only a soft
damp cloth. Do not use water, detergents or alcohol.
9. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
10. Lead-Acid batteries can emit explosive gases when charged. Prevent sparks and fire
sources close to the battery. Provide good ventilation – appliance should be used only in well
ventilated areas.
6
To Next Page
Loading...
