TROUBLESHOOTING &
BATTERIES RECYCLING
Problem Cause and correction of the defects
Device is not
responding.
Hoverboard is not activated.
Please activate our device with the on / off button (2).
Battery is not fully charged.
Please charge the battery.
A violent shock (caused by a rollover, for example) has
shaken our unit. Since then the LED warning light is red.
Please deactivate our device and then reactivate.
Reduce the speed. Please get off carefully and calmly.
LED warning light
(7) is active and
a signal is heard.
You are travelling at too high a speed.
You are in a steep gradient right now.
Please reduce your speed. Then please calmly and
carefully get off the board.
Please reduce your speed. Get calmly and carefully
off the device. Please clean the wheels from foliage,
pebbles, loose chippings, etc. until they begin to turn
again.
Reduce your speed. Get off the Hoverboard calmly
and carefully. Please charge the battery immediately
and fully.
Wheels (3) are locked.
Too low battery .
24
To Next Page
Loading...
