10
1. As shown in the figure below, install 4 sensor foam pads under the
pedal bracket. Place the pedal mounts onto the foot pedals of your
self-balancing scooter with the front wheel facing forward. Ensure the
pedal mounts are centered on the foot pedals of your scooter as much
as possible. Ensure the foam pads are attached to the bottom of the
pedal mounts so that the seat does not touch the footpad sensors on
the hoverboard.
2. Secure your Seat Attachment to your hoverboard using adjustable
velcro straps. With the velcro side facing away from your scooter, attach
one hook of each adjustable strap to the back of each pedal mount.
To Next Page
Loading...
