Everdure KILN - Burner Performance and Ignition; Flame Stability Check; Manual Ignition

12
EN
CHECKING THE BURNERS FOR FLAME STABILITY:
Visually check the burner ames for correct function when the unit’s operating by inspecting the burner ame/ames
with the stone (EKILN R Series - 2 burner only) removed. A good ame should be blue with some yellow tipping.
Note: take care when viewing the burner operation not to lean into the ame; failure to do this may result in personal
injury.
MANUAL IGNITION:
In the instance where the automatic ignition fails, the product can be lit with the provided matchstick holder.
MAIN BURNER:
Using the matchstick holder, carefully ignite the main burner as shown below.
BOOST BURNER:
Using the matchstick holder, carefully ignite the lower burner through the lower burner viewing port.
This is only applicable to boost burner models.