13
EN
TROUBLESHOOTING:
Burner will not ignite when using the igniter:
Burner ame is erratic:
Gas is leaking from connections:
Turntable not working:
Cylinder valve is not on Turn cylinder valve on
Cylinder is empty Replace with a full cylinder
Igniter button is not working Check battery
Igniter is not sparking Contact the Service Centre
Flame is burning inside burner
(hissing sound)
Turn o burner, allow to cool and re-ignite
Regulator is faulty Contact the Service Centre
Injector is partially blocked
Clean injector with a toothbrush. Do not drill out or use wire.
Do not remove the injector. Contact the Service Centre
Connections are loose
Tighten loose connections (do not over-tighten) and leak test under pressure
with a soapy water solution (page 2)
Hose has deteriorated Replace hose (Contact the Service Centre)
Gas valve is faulty Contact the Service Centre
Threads are damaged Contact the Service Centre
Turntable not turning
Check that the power cord from the power adaptor is connected correctly and
that the power is on at the main power board.
Check if batteries are tted and are properly installed in the battery
compartment.
Check if batteries are full of charge and replace if needed.
Turntable is broken Contact the Service Centre
Switch or wiring damaged Contact the Service Centre
To Next Page
Loading...