INSTALLATION GUIDE
AP300
The AP300 Wireless Access Point installation must be performed by certified technicians only
and in compliance with all local/state/federal safety requirements. All warnings and information in
this manual should be read and understood before proceeding with installation. Any noncompliance
by the installer or end user voids the warranty of the product.
General Safety
You can be killed or injured if performing antenna installation near electrical power lines.
Carefully read and follow all instructions in this guide. Ensure that there are no high voltage or
electrical fields nearby.
Working Aloft Warning
When working on tower or roof, individuals must wear safety belts. Tools must be tied to the
individual using them. Workers below must wear safety helmets.
Lightning Activity Warning
Make sure not to connect or disconnect cables during periods of lightning activity. A surge
protective device should be installed to prevent potential damage from very high surges, for
instance, the peak surges caused by lightning.
Explosive Device Proximity Warning
Do not operate network devices close to explosive merchandise or in explosive environments,
for example, in the vicinity of a gas station.
Antenna Placement Warning
Do not install any antenna near overhead power lines or other electric light, or where the
antenna can come into contact with such circuits.
Grounding Warning
Protect your AP300 Wireless Access Point by installation of grounding lines. The ground
connection must be complete before connecting power to the AP300 Wireless Access
Point
enclosure.
The
requirement
of
grounding
is
to
make
sure
the
resistance
is
less
than
5 ohms between
the ground termination point to grounding tier.
Power Installation Warning
The installation of the power switch must be performed by a certified technician. The power
switch is not supplied with the AP300 Wireless Access Point. The power cord must be assembled
by a certified technician, and the final assembly must comply with related requirements.
Solar Irradiation and High Temperature Protection
Pay attention to the level of sunlight, which can increase the working temperature of the
AP300 Wireless Access Point to higher than specifications allow.
To Next Page
Loading...