Everest EGC 75 A - User Manual

VALID FOR UNITS PRODUCED SINCE SEPTEMBER/2015
ICE CUBE MACHINES
EGC 50 A
EGC 75 A
EGC 100 A / 150 A EGC 150 MA
EGC 150 MA / 140 EGC 150 MA / 250 EGC 300 MA / 250
SINCE 1966
TECHNICAL MANUAL
MARÇO/2017 REV.170331

Summary

Important Information

Operating Principles

Scheduled Maintenance

Equipment Failure Management

Symptom: Water Shortage or Low Water Flow Rate

Symptom: Plastic Trough Cannot Be Lowered

Symptom: Trough (35) Is Lowered But Does Not Reach The Lowest Point

Symptom: By-Pass Cycle Over 2 Minutes

Symptom: Trough (35) Is Suspended, But Does Not Reach The Lowest Point

Symptom: Trough (35) Rises, But Does Not Achieve The Highest Point

Symptom: Throughout The Water Inlet, The Plastic Trough (35) Does Not Stay At The Highest Point

Defect Analysis

Machine Does Not Work

Troubleshooting guide for the machine not operating, with probable causes and corrections.

Water Shortage or Low Water Flow

Diagnosing and resolving low water supply issues, including filter and valve checks.

Water Trough Goes Up and Down Continuously

Continuous Entrance of Water in the Trough

Low Ice Production

Machine Working But Not Producing

Cubes Do Not Detach From the Evaporator

Adjustment and Replacement of Main Components

Displacement System and Trough

Adjustment of Water Level and Ice Cube Height

Circuit Board Does Not Control Any Component

Components That Send Information to the Board

Components Controlled by the Circuitboard

Inoperative Water Valve

Gas Load; Replacement of the Cooling Compressor

Everest EGC 75 A Specifications

General

Daily Ice Production	75 kg
Ice Type	Cube
Voltage	220-240V
Frequency	50 Hz
Cooling System	Air Cooling