16
TROUBLESHOOTING
Problem Cause Remedy
No water flows Cold feed isolation valve
closed
Open Valve
Incorrect connection of
pipes
Correct error
Valve blocked Clean or replace valve
The appliance does not
supply hot
water.
The temperature
selector is set to
“LOW”.
Switch the appliance ON
by turning
the temperature selec-
to r.
No power at the appli-
ance.
Check the plug / fuses in
the domestic
fuse box.
Appliance is switched off Turn appliance on
Loud boiling noises in-
side the appliance.
The appliance is scaled
up.
Have the appliance des-
caled by a
qualified contractor.
If you cannot remedy the fault, notify your qualified contractor. To facilitate and
speed up your enquiry, please provide the numbers from the type plate.
To Next Page
Loading...