Country-specific approvals and certifications
The test symbols can be seen on the type plate.
Extreme operating and fault conditions
In the case of faults, a peak temperature up to 100 °C may briefly occur
in the system.
Details on energy consumption
The product data complies with EU regulations relating to the directive
on the ecological design of energy related products (ErP).
Heat-up performance
The heat-up period depends on the degree of scaling and residual heat.
Using a cold water supply at 10 °C and a maximum temperature setting
60
o
C will be achieved in 8 minutes
HEAT UP PROFILE
19
To Next Page