EverFocus EHD525EX Operation Instructions

EVERFOCUS
1/3” Sony ExView Day/Night
Rugged Dome Color Camera
Operation Instructions
Model No.
EHD525EX
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not install the camera near electric or magnetic fields.
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,
audio speakers since the magnetic fields generate from above devices will distort the video
images.
2. Never disassemble the camera nor put impurities in it.
Disassembly or impurities may result in trouble or fire.
3. Never face the camera toward the sun.
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.
4. Keep the power cord away from water and liquid.
Touching the wet power cord may result in electric shock.
5. Never install the camera in areas exposed to water, oil or gas.
Water, oil or gas may result in failure, electric shock or fire.
6. Cleaning
Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from
the camera body. Use lens tissue or a cotton swab and ethanol to clean the sensor and the
camera lens.

EverFocus EHD525EX Specifications

General

Pickup device:	SONY 1/3” interline transfer color EXView CCD
Sensitivity:	0.1 lux / F=1.2
Vari-Focal Lens:	3.6-9mm / 9-22mm IR Lens
IR Cut Removable:	Yes (Auto IR Cut Removable and B/W Sensitivity Enhanced)
Electronic shutter:	Up to 1/100, 000
IRIS Control:	Auto
Auto white balance:	YES
Auto gain control:	ON/OFF switch
Back light comp.:	ON/OFF switch
Picture element:	NTSC: 768(H) × 494(V) PAL: 752(H) × 582(V)
Gamma correction:	0.45
Video output:	1.0Vp-p, 75ohm
Horizontal Resolution:	520 TV Lines
S/N ratio:	>52dB(AGC off)
Line Lock:	ON/OFF switch for 24V AC
Flickerless:	ON/OFF switch
Sync. mode:	Internal Sync. /Line lock (Only for AC24V)
Weatherproof Ratings:	IP66
Heater auto activated temperature:	50 degree Fahrenheit
Operating temperature:	-40 ~ 122 degrees Fahrenheit, 20~80%
Power source:	12V DC+/-10%, 24V AC+/-10%
Power Consumption:	5W Max. (15W when heater active; thermostatically controlled)

Weight and Dimensions

Dimension:	5.1” (W) x 3.9” (H) x 5.1” (D).
Weight:	3.7 lbs