Evergreen Palm - User Manual

Palm Quick User Guide
This Quick User Guide runs through the Control Unit functions. Refer to the User Manual for full details.
‘Auto-Detect’
Press soft and firm together to activate
‘Auto-Detect’. The indicator light will flash and
the system will start detecting the client's weight
distribution to set the pressure. The indicator
light will stop flashing when complete.
Soft or Firm
Controls the air pressure output level.
Press Firm and the pressure will increase
to provide increased support.
Cycle
Select your desired Cycle time.
‘Auto-Lock’
The Control Unit locks when untouched
for 30-seconds to prevent tampering
with settings. To unlock, press and hold
the Lock for 3-seconds.
Mode
Choose from one of three Therapy Modes
(Alternating Pressure Therapy, Pulsate Therapy,
Constant Low Pressure Therapy).
‘Auto-Firm’
Surface air cells inflate to max for
caregiver management (takes up to 5
mins). Will automatically return to the
last Mode of operation after 20 minutes.
Operate or Standby
Press to start operating the mattress
or to go into Standby.
Alarm Mute
Press Alarm Mute to temporarily suspend
the audible alarm. Should the issue
persist, the alarm will resume. If the
mains power is removed from the
control unit or the power cable is
unplugged, an audible alarm will sound.

Evergreen Palm Specifications

General

Category	Control Unit
Current Rating	5A
Weight	0.5 kg
Operating Temperature	-20°C to 60°C
Protection	Overload, Short Circuit

Summary

Palm Quick User Guide

Control Unit Functions Overview

Details the functions of the control unit buttons including Auto-Detect, Soft/Firm, Lock, Mode, Cycle, Auto-Firm, Operate/Standby, and Alarm Mute.

Palm Initial Setup Guide

Unpacking and Initial Connections

Covers unpacking the control unit, surface, and power cord, and connecting the air hose and detection cable.

Mattress and Control Unit Placement

Guides on placing the mattress on the bed deck and securing the control unit at the foot end.

Powering On and Inflation

Instructions for turning on the control unit, initial inflation, and calibration time required.

Client Placement and Auto-Detect

Procedure for placing the client on the surface and initiating the 'Auto-Detect' function for pressure calibration.

Mode Selection and Auto-Firm

Guidance on selecting therapy modes and using 'Auto-Firm' for caregiver management.

Lock-Out Feature

Explanation of the automatic 'Lock-Out' feature and how to unlock the control unit.