EVERKITCH ATLAN - Fan Speed and Delay Operation; Troubleshooting; Motor and Light Issues; Oil Leakage and Suction Problems

9
4.2 Press the (Medium) button, the indicator light of and will beam, and the
motor runs at low speed. Press it again and the motor will stop, the indicator light of
and will be off.
4.3 Press the (High) button,the indicator light of and will beam, and the
motor runs at low speed. Press it again and the motor will stop, the indicator light of
and will be off.
4.4 Low speed, mid speed and high speed cannot work at the same time. When hood
is at high speed, press low speed, it will turn to low speed at once; when it is at low
speed, press middle speed, it will turn to middle speed immediately, and so on.
5. Delay button :
The delay button is use for delay function only when the cooker hood speed
button and lamp button is in use. Press the delay button once to enter to delay
working status, its indicator light will be lit on. The cooker hood will run for 5 minutes
and then turn off automatically, the lamp will be off as well, all the indicator lights will
extinguish. The cooker hood enters to standby mode.
TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not
work, motor does
not work
House fuses blown
Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to
power outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet
are not tightly sealed
Take down the one way valve
and seal with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
Lights not working
Broken or faulty bulbs
Replace blubs as per this
instruction.
Insufficient suction
The distance between the
cooker hood and the gas top is
too far
Refit the cooker hood to the
correct distance.