CORRECT LOAD THE BLAST CHILLER
AVOID overloading the blast chiller beyond the set limits shown in the table
NO OK
Do not place the trays too close to each other so as to avoid uneven air circulation inside the blast
chiller
NO OK
Do not place the trays too far away from the evaporator
NO OK
Do not concentrate the trays in one area of the blast chiller in case the load is not complete; distribute
its height evenly
NO OK
In case of interruption or failure of the power supply circuit, prevent the opening of the doors in order
to maintain a uniform temperature inside the blast chiller.
If the problem persists longer than a few hours it is recommended to move the material to a suitable
place.
To Next Page
Loading...
