3
Eversense E3 CGM Quick Reference Guide
Getting Started Steps
Charging the Smart Transmitter
1. Plug the standard
end of the USB cable
into the adapter on
the USB port.
2. Plug the micro end
of the USB cable
into the charging
cradle USB port.
3. Line up the four gold pins on the bottom
of the smart transmitter with the four gold
pins on the charging cradle.
Once fully charged (about 15 minutes), a
small green light appears on the top side
of the smart transmitter. Remove the USB
cable from the charging cradle after it is fully
charged by pulling back on the tab on the
cradle, and lifting the smart transmitter out.
Before you begin, you need:
• A compatible mobile device.
– For a list of compatible devices, visit www.eversensediabetes.com/compatibility.
• Wireless internet connection.
• Fully charged Eversense E3 Smart Transmitter.
To Next Page
Loading...
