EVERSPRING HSC04-0 - User Manual

- 1 -
HSC04-0 U-Net Gateway
User Manual
1. Introduction
The HSC04 Gateway is a member of the U-Net series and is fully compatible
with any U-Net enabled devices. It can remotely control and monitor your
U-Net enabled devices. Whether onsite or logged in through the internet, you
will always have access to control and monitor your control system. With this
system you can achieve a better control of your home security to make your
life safer and easier than ever.
2. Appearance
Figure 1 HSC04 Appearance
2.1 Sockets
DC Jack: DC power voltage
9V, current 2A.
RJ-45 socket: HSC04 has
an Ethernet hub function
and is equipped with two
linked RJ-45 sockets.
2.2 Buttons
HSC04 has two buttons:
One reset button and a
connection button (next to
the RJ-45 socket).
■ Reset Button:
This button will reboot the system. The user can press this button when the
system is halting.
Note: HSC04 is equipped with internal battery power, which will be
automatically switched to when DC power is cut off. The device will still
be halting.
■ Connection Button:
‧ Manually enable the bind function:
Press the connection button once after the system is powered on.
 ‧ Manually cancel the bind function:
Press the connection button once when the system is in bind mode.
2.3. LED
Figure 2 HSC04Front View
LED1 LED2 LED3 LED4

Summary

Introduction

Device Appearance

Device Sockets

Details the DC power jack and two RJ-45 Ethernet sockets on the HSC04.

Device Buttons

Describes the reset button and the connection button on the HSC04.

Front Panel LEDs

Introduces the LED indicators visible on the front view of the HSC04.

LED Status Indicators

Power LED States

Explains the meaning of the Power LED (LED1) states: on, writing data, and not synchronized.

Connection LED States

Details Connection LED (LED2) states for OpenVPN, DHCP, firmware upgrade, binding, and device addition.

Network 1 and 2 LEDs

Describes the status of Network 1 (LED3) and Network 2 (LED4) LEDs for RJ-45 socket connections.

Installation Procedure

U-Net Binding Operation

Initiating Device Binding

Instructions on how to start the U-Net binding process using the connection button.

Binding Success and Cancellation

Details on successful binding and how to cancel the binding mode.

Binding Mode Timeout

Explains the behavior and LED indication during binding mode timeout.

Health and Environmental Precautions

FCC Compliance Statement

EVERSPRING HSC04-0 Specifications

General

Category	Gateway
Model	HSC04-0
Manufacturer	EVERSPRING
Protocol	Z-Wave
Operating Frequency	868.42 MHz
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C