evertz EQX-IP18-IPG - User Manual

EQX–IP18-IPG
EQX Input and IP Gateway Module
User Manual
© Copyright 2016
EVERTZ MICROSYSTEMS LTD.
5292 John Lucas Drive
Burlington, Ontario
Canada L7L 5Z9
Phone: +1 905-335-3700
Sales: sales@evertz.com Fax: +1 905-335-3573
Tech Support: service@evertz.com Fax: +1 905-335-7571
Web Page:
http://www.evertz.com
Version 1.0, May 2016
The material contained in this reference guide consists of information that is the property of Evertz Microsystems and is intended solely for the use
of purchasers of the EQX-IP18-IPG product. Evertz Microsystems expressly prohibits the use of this guide for any purpose other than the
operation of the contained in this reference guide consists of information that is the property of Evertz Microsystems and is intended solely for the
use of purchasers of the EQX-IP18-IPG product. Due to on going research and development, features and specifications in this manual are
subject to change without notice.
All rights reserved. No part of this publication may be reproduced without the express written permission of Evertz Microsystems Ltd. Copies of
this manual can be ordered from your Evertz dealer or from Evertz Microsystems.

Summary

IMPORTANT SAFETY INSTRUCTIONS

1. OVERVIEW

Features & Benefits

Lists key features and advantages of the EQX-IP18-IPG module, including inputs, interfaces, and compatibility.

VIDEO;IP CONNECTIONS

2. SPECIFICATIONS

2.1. SERIAL DIGITAL VIDEO INUPUTS

Details supported video standards, number of inputs, impedance, and input equalization.

4. INSTALLATION

4.1. INSTALLATION OF REAR PLATE OR MODULE INTO TOP HALF OF A EQX26 FRAME

Step-by-step instructions for installing the module's rear plate into the top half of an EQX26 frame.

4.2. INSTALLATION OF REAR PLATE OR MODULE INTO BOTTOM HALF OF AN EQX26 FRAME

5. SETTING GENLOCK REFERENCE

5.1. NTSC REFERENCE

Details the dip switch settings required to configure the NTSC reference signal for genlock.

5.2. PAL REFERENCE

7. WEB INTERFACE CONFIGURATION

7.1. LOGIN

Instructions on how to access and log into the module's web interface using default credentials.

7.2. SYSTEM TAB

7.2.1. Data Port Configuration

Allows configuration of data ports with IP address, Netmask, and Gateway settings.

7.2.2. Data Port Monitor

7.2.5. Genlock Configuration

7.4. INPUT ROUTE CONTROL

7.4.1. Route (Grid; Management)

Shows input routing grid, allowing management of connections between SFP inputs and SDI outputs.

7.5. OUTPUT ROUTE CONTROL

7.5.1. Output Route (Grid;Management)

Shows output routing grid, managing connections from DIN SDI inputs to SFP outputs.

7.6. DIN SDI INPUTS

7.6.1. SDI Input Control

7.7. IP OUTPUT

7.7.1. IP Output Control

Controls IP output status, source/destination IP addresses, and UDP ports.

7.8. IP INPUT CONTROL

7.8.2. IP Input Control

7.9. IP INPUT MONITORING

7.10. SDI OUTPUT

7.11.1. Router Source

7.11.2. Router Source

7.12. VIDEO NOTIFY

7.12.1. Video Monitoring Control

7.12.2. Video Input Notify

7.12.3. Video Output Notify

7.13. AUDIO NOTIFY

7.13.1. Audio Monitoring Control

7.13.2. Audio Input Notify

7.13.3. Audio Output Notify

7.14. IP NOTIFY

7.15. NOTIFY

evertz EQX-IP18-IPG Specifications

General

Brand	evertz
Model	EQX-IP18-IPG
Category	Gateway
Language	English