Everwell MRTH - Operating Modes: Cooling and Heating; Cooling Mode Operation; Heating Mode Operation

OPERATING INSTRUCTIONS
COOLING MODE
The cooling function allows the air condit-
ioner to cool the room and at the same time
reduces Air humidity.
COOL
To activate the cooling function ( COOL ) , press the
MODE button until the symbol ( COOL )
appears on the display.
12
HEATING MODE
OFF
ON
C
AUTOQUIET
POWE R FUL
hr
DELAY
TIMER
HEALTHY
AIR
SWING
FAN
SPE ED
ON/OFF
MODE TIME R
FAN SPEED SUPER E CO
SWING SLE EP HEALTHY
DRY
FAN
HEAT
COOL
FEE L
ANTI-MILDEW
C
h
ON
COOL
1
2
3
OFF
C
AUTOQUIET
POWE R FUL
TIMER
HEALTHY
DRY
FAN
HEAT
COOL
FEE L
ON
HEAT
ON
hr
DELAY
AIR
SWING
FAN
SPE ED
C
h
1
ON/OFF
MODE TIME R
FAN SPEED SUPER E CO
SWING SLE EP HEALTHY
ANTI-MILDEW
1
2
3
1
TIMER
HEALTHY
TIMER
HEALTHY
The cooling function is activated by setting the button
or at a temperature lower than that of the room.
To optimize the function of the Air conditioner, adjust
the temperature (1) , the speed (2) and the direction
of the air ow (3) by pressing the button indicated.
HEAT
The heating function allows the air conditi-
oner to heat the room.
To activate the heating function ( HEAT ) , press the
MODE button until the symbol ( HEAT )
appears on the display.
With the button or set a temperature higher than
that of the room..
To optimize the function of the Air conditioner adjust
the temperature ( 1 ), the speed ( 2 ) and the direction
of the air ow ( 3 ) by pressing the button indicated
In HEATING operation, the appliance can automatically
activate a defrost cycle, which is essential to clean the
frost on the condenser so as to recover its heat exchange
function.This procedure usually lasts for 2-10 minutes
during defrosting,indoor unit fan stop operation.
After defrosting ,it resumes to HEATING mode
automatically.
If the appliance is tted with a electrical heater,
which delays appliance to startup in a few seconds
to ensure an immediate output of hot air (Optional ,
depends on the model).