OR
QUICK GUIDE
Please review this guide carefully before using the product.
· Charging Time
100 minutes
(On full discharged: 150 minutes)
· Operating Time
100 minutes (Two times of mop
cleaning with one full charging)
After 50 minutes of cleaning, the robot
will stop automatically to inform the user
to change mop heads and put more
water in the water supply mop kit.
Prevent the battery discharge by turning
off the power switch in the main unit.
① Wet mops thoroughly in
water and apply them in the
main unit after wringing
them out.
④ Close the rubber stopper of the water supply mop kit
and attach the water supply mop kit into the bottom
of the main unit. (Pressing it while turning side to side
will install it with a click sound.)
⑤ Turn on the power switch located on the
bottom of the main unit. (Turning from
side to side, it is installed with a click sound.)
⑥ Start cleaning by pushing the button
of main unit or the remote control.
② Attach the mop pads to fit the
joint parts to the holes of the
water supply mop kit.
③ Open the rubber stopper of
the water supply mop kit and
fil the water into the water tank.
Components
How To Use
RS700 Main Unit
Water Supply Mop Kit
Microfiber Mops
Remote Control
Power Adapter
Please check before using the product!
· Please charge the product fully before the
first operation.
· When charging the battery, the button on
the main unit and the remote control does
not work .
· Do not use any other power adapter other
than the adapter which came with the unit.
Yellow LED Blinks
Low Battery Level
Blue LED Blinks
Medium Battery Level
LED is Off
Full Battery
Charging
How to Start the Wet Cleaning Mode
Correct Example
Incorrect Example
Right Direction
Wrong Direction
To Next Page
General