EVGA GeForce RTX 2080Ti User Manual (English)

To Next Page

2-way SLI: Install your second GeForce

graphics card in the secondary PCIe x16 slot.

Connect the two cards together using a 2-way SLI bridge.

NVLink

technology is only supported by each GPU Speciﬁcation.

Install your ﬁrst GeForce

graphics card into the Primary PCIe x16 slot

(the Primary slot is the one closest to the CPU).

Attention: It is very important that you wait until the graphics card has cooled down before taking the card out of the system.

Turn o your computer, disconnect the power cord and remove any existing graphics card(s).

Remove the slot covers that correspond to the PCIe slots you are installing the GeForce

graphics card in

(if there was no existing graphics card).

Note : All of the graphics cards in an SLI

conﬁguration must be identical.

Install the GeForce

graphics card, as shown below. If this card is going into an SLI

conﬁguration, follow the

directions for the number of cards you will be installing.

Hardware Installation

Need help?

Do you have a question about the EVGA GeForce RTX 2080Ti and is the answer not in the manual?

EVGA GeForce RTX 2080Ti Specifications

General

CUDA Cores	4352
Base Clock	1350 MHz
Boost Clock	1545 MHz
Memory	11GB GDDR6
Memory Interface	352-bit
Memory Bandwidth	616 GB/s
Memory Speed	14 Gbps
TDP	250W
Power Connectors	2 x 8-pin
Recommended PSU	650W
DirectX Support	12
VR Ready	Yes
Maximum Resolution	7680x4320
PCI Express Interface	PCIe 3.0 x16
GPU	NVIDIA GeForce RTX 2080 Ti
Outputs	3 x DisplayPort, 1 x HDMI, 1 x USB Type-C
Cooling	Varies by model
OpenGL Support	4.6
SLI Support	NVLink