Need help?Do you have a question about the Evh 5150 ICONIC Series and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Power Output | 40W |
| Tubes | Yes |
| Preamp Tubes | 3 x 12AX7 |
| Power Tubes | 2 x 6L6 |
| Inputs | 1 x 1/4" |
| Reverb | Yes |
| Effects Loop | Yes |
| Outputs | 1 x 1/4" |
| Weight | 12.7 kg |
| EQ | 3-band EQ |
| Speaker Output | 8 ohm, 16 ohm |
Input jack for instrument and pushbutton for selecting channel one or two. Footswitch overrides selection.
Controls preamp gain and voicing for channel one, offering clean to medium distortion.
Controls preamp gain and voicing for channel two, offering high to heavier distortion.
Reduces noise and tightens attack specifically on channel two.
Shared passive controls for low, middle, and high frequencies.
Post-preamp volume for each channel and a footswitchable master volume boost for solos.
Controls for reverb level, power amp low-frequency response, and ultra-high frequency tone.
Power input, power switch, and standby switch for amplifier operation and tube warm-up.
Switch to select 40W or 10W power output and a mute switch for quiet operation.
Analog speaker-emulated XLR output for direct connection to sound reinforcement or recording.
Switch to alleviate hum and output for connecting to external equipment or mixers.
Connect external effects via SEND/RETURN and connect the included footswitch for channel/boost selection.
Jacks for connecting speaker cabinets and a selector for matching impedance (4, 8, or 16 ohms).
Details power requirement, output wattage range, input/output impedance, and fuse types.
Lists footswitch type, tubes used, and the physical dimensions and weight of the amplifier.
To Next Page
