EVOCA Saeco IDEA RESTYLE DUO - Page 2

Conceo Evo Cleaning Guide
CLEANING MILK COMPONENTS
COFFEE DISPENSING SPOUT & CAPPUCCINATORE
Remove the upper protecon cover by pulling it outwards.
Remove the fork and the crema adjusng lever.
Unscrew the lower knob to remove the lower protecon cover.
Remove the ng connecng the milk tube to the Cappuccinatore
connector, then remove the milk dispensing spout and the milk tube.
Remove the Cappuccinatore casing and the
Cappuccinatore body cap.
Remove the temperature adjusng lever.
Remove the coee dispensing spout by
pulling it outwards and dismantle it.
Wash all parts in cleaning soluon using a small brush.
Use only milk system and coee machine-specic products.
Follow the dosing direcons on the product packaging.
Make sure to mechanically remove all visible residues and
lms
Rinse with running water and thoroughly dry all the parts.
Reinstall all parts in reverse order.
1
4
5
7
6
8
9
10
2
3
2
3
TUBES CLEANING CYCLE
1
Immerse the milk tube into a container with water and press on the Milk buon. (Fig. 1)
Do not use hot water.
During the cleaning cycle process, clean the cooling unit with a so cloth. (Fig. 2)
At the end of the cycle, remove and empty the container. Do not drink this water.
Replace the milk tube inside cooling unit.
Make sure the milk tube is correctly posioned so it is supplied with milk.
Cafecon | Evoca recommends using Milk System Cleaning Tablets from Evoca, or equivalent
cleaning product.
Make sure to always follow the product manufacturer’s instrucons.
RECOMMENDED PRODUCT
Product code: 962961
C
L
E
A
N
E
R
4
Fig. 1
Fig. 2
Technical Support: 800-561-6162 # 310
21DOC09 Rev. 1 / 2022-09
Upper Protecon
Cover
Fork
Crema Adjusng Lever
Cappucc. Body Cap
Cappucc. Casing
Milk Tube
Coee Dispensing
Spout
Lower Protecon
Cover
Temp. Adjusng Lever
Cappucc. Connector
Milk Dispensing Spout