1. Press 【mode】to select the cold storage mode.
2. Press【+】or 【-】to set the temperature for cold storage. Set the temperature range
between - 6 ℃ and 5 ℃. The lower the temperature, the bigger the cooling capacity.
3. The unit may not reach the set temperature. This depends on the ambient temperature and
does not affect the cooling function. The unit will stop automatically when the cold storage
function is done.
4. After completion of the cold storage function, the air conditioner will switch to standby mode
automatically.
Note:
During cold storage function, air will be moved at high speed and the louvres will be at the maximum
discharge angle. The stored heat is currently being dissipated from the water. Open the doors and
windows in a small room for ventilation. A lot of heat will be blown into the room during the cold
storage function.
- The actual water temperature in the water reservoir is displayed during cold
storage.
- The air inlet and air outlet must not be covered.
7. Heat storage
1. Press 【mode】to select the heat storage mode.
2. Press【＋】or【-】 to set heat storage temperature, between 20℃ and 30℃.
After heat storage completes, the unit enters in standby and temperature-holding status.
Note:
During the heat storage function, the air exhaust fan is closed, and no air will be blown out of the
mobile air conditioner.
- The actual temperature of the water in the tank is displayed during heat storage.
8. Heating
1. Press 【mode】to select heating mode.
To Next Page
Loading...