2. Press【+】or 【-】to set the desired temperature. Set the temperature between the 16℃
and 32℃.
3. Press 【wind speed】to set the desired speed. There are four positions: low, medium, high or
automatic.
4. Press【swing wind】to set the discharge blades in the correct position. The slats can move up
and down automatically in the swing position and can be locked in the desired position.
Note:
During heating, the actual temperature of the water in the water tank is displayed.
When the heating capacity of the water in the water tank is used up (water temperature is 2°C), the
air conditioning automatically stops heating. The water should then on to heat up, in order to be able
to again heat. It is also possible to ‘heat storage’ function to use to allow the water to warm up. It is
also possible to replace the water in the air-conditioning system with hot water in order to switch back
to heating mode.
9. Ventilation
1. Press 【mode】to select the fan mode.
2. Press 【wind speed】to set the desired speed. There are four modes: low, medium, high or
automatic.
3. Press【swing wind】to set the discharge blades in the correct position. The slats can move up
and down automatically in the swing position and can be locked in the desired position.
Note:
During the fan mode the actual air intake temperature is displayed.
10. Preset
1. Press 【preset】to select the preset mode and then select the cold storage preset or the heat
storage preset mode.
2. Press 【preset】to confirm the preset cold storage or heat storage.
To Next Page
Loading...