15
CLEANING THE VARIPUMP
Step 9: Wipe clean to remove any excess
dirt.
Step 10: Re-fit the impeller housing.
This can be positioned at multiple angles.
Step 11: Re-fit the handle and tighten up
the screw.
Step 12: Re-fit all four screws around the
impeller housing and tighten up.
Step 13: Re-fit the base plate. Step 14: Clip on the strainer basket
(if applicable).
Step 7: Carefully pull away the impeller
housing.
Step 8: Use a brush to clean inside and
around the impeller.
RE-CONNECT THE INLET / OUTLET PIPEWORK AND TURN THE POWER BACK ON
To Next Page
Loading...