delay between pressing the fire button and generating vapor. Because preheat is temperature based, it
will not overheat or burn the vapor.
Attaching a New Atomizer
The DNA 200 uses the resistance of the atomizer to calculate the temperature of the heating
coil. It continually looks to see whether a new or changed atomizer has been connected. If you are using
temperature protection, be careful to only attach new atomizers that have cooled to room temperature
to the device. If a new atomizer is attached to the DNA 200 before it has cooled down, the temperature
may read and protect incorrectly until the new atomizer cools.
When you connect a new atomizer or disconnect and reconnect your existing atomizer, the DNA
200 will prompt you to confirm this change. When you fire the first time, before activating the DNA 200
will prompt “New Coil? UP YES/DOWN NO”. When you see this prompt, if you have attached a new
atomizer, press the UP button. If you have disconnected and reconnected the same atomizer, press the
DOWN button.
To Next Page
Loading...
Need help?
General