Cleaning and maintenance
Before performing any work on the equipment, pull the power plug.
Cleaning
To reduce the fire hazard，keep the lawnmower, and particularly the motor, free of grass,
leaves, or excessive grease..
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.If the dirt
does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Do not use forced water and avoid welting the motor or the electrical components
Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition
Oil the wheel pins
Check the blade’s balance after sharpening. After work has been carried out on the blade,
reassemble as shown in the drawing, tightening the central screw (Fig.11)
Storage
Thoroughly clean the whole machine and its accessories.
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
Don’t keep it in plastic bags to avoid humidity build-up.
Warranty
This warranty covers all material or production flaws excluding:
D
efective parts subject to normal wear & tear such as bearings, brushes, cables, and plugs,
or accessories
Damage or defects resulting from maltreatment, accidents or alterations; nor the cost
transportation.
We also disclaim all liability for any bodily injury resulting from inappropriate use of
tool.
Definitely excluded from the warranty is damage resulting from fluid permeation, excessive
dust penetration, intentional damage (on purpose or by gross carelessness), inappropriate
usage (use for purposes for which the device is not suitable), incompetent usage (e.g. not
following the instructions given in the manual), inexpert assembly, lightning strike, erroneus
net voltage. This list is not exhaustive.
To Next Page
Loading...