Chapter 5
Powering On the Base Unit with its Extension Cards
5. Powering On the Base Unit with its Extension Cards
When the Base Unit is powered on, it takes approximately 25 seconds for the unit to go
through its self-test procedure. The slots in which the extension cards have been inserted
and their type are detected during this process.
If the boot process completes normally, you should observe the following LED status
• Base Unit USR flashing green slowly
• Extension Card None
- Note -
Would the USR LED of the Base Unit be flashing RED, it might be because the Extension Card
was improperly inserted (for example in a wrong slot).
Page 14 / 17 eWON Flexy 3G GSM Extension Card FLB 3202 | IG 019
To Next Page
Loading...