EWS EWS-1354-HF - User Manual

4.2-1
www.EWSWATER.com office: 702-256-8182 (m-f; 8:30-4:30, pst) fax: 702-256-3744 customerservice@ewswater.com
Care and Use Manual
Tank EWS/CWL Series Appliances
Information Provided for the Proper Set-Up, Installation and
Start-Up of the following Appliances:
 EWS Series of Whole Home Filtration and Physical Conditioning:
EWS-1035 LTD, EWS-1054, EWS-1354, EWS-1354-HF, EWS1354-11/2”
 CWL Series of Whole Home Filtration:
CWL-1035 LTD, CWL-1054, CWL-1354, CWL-1354-HF, CWL-1354-11/2”
To the Consumer:
Retain this Care & Use Manual for Maintenance and Information
You Must Register this Product - It is a Requirement for Warranty
ALL PRODUCT PROUDLY MANUFACTURED AND ASSEMBLED IN THE USA

EWS EWS-1354-HF Specifications

General

Brand	EWS
Model	EWS-1354-HF
Category	Water Filtration Systems
Language	English

Summary

Care and Use Manual for Tank EWS;CWL Series Appliances

How to Select the Right Product for Your Home

Selecting Your EWS or CWL Unit

Guide to choosing between EWS and CWL series based on water source and needs.

All Units - Installation Summary: 12 Steps

All Units - General Information and Pre-Installation Checklist

Water Pressure and Flow Rate Requirements

Necessary water pressure and flow rates for system operation and backwash.

Location, Electrical, and Plumbing Considerations

Guidelines for tank placement, electrical supply, and existing plumbing conditions.

Drain Connection Specifications

Requirements for drain line size, length, and flow control.

EWS & CWL 1035, 1054, 1354 Installation Schematics

EWS;CWL-1035 LTD Schematic

Visual guide for the installation of the EWS/CWL-1035 LTD unit.

EWS;CWL-1054 Schematic

Visual guide for the installation of the EWS/CWL-1054 unit.

EWS;CWL-1354 Schematic

Visual guide for the installation of the EWS/CWL-1354 unit.

EWS & CWL 1035, 1054, 1354 Preparation for Installation

EWS & CWL 1354-HF Installation Schematic

EWS & CWL 1354-HF Preparation for Installation

EWS & CWL 1354-11;2 Installation Schematic

EWS & CWL 1354-11;2 Preparation for Installation

Unboxing and Valve Head Check

Plumbing Line Connections

Steps for connecting the main water supply lines to the unit.

All Units - Start-Up Procedure

Step 1: Fill the Tank with Water - Slowly!

Instructions for slowly filling the tank to prepare for operation.

All Units - Start-Up Procedures: Electrical and Time Setting

Step 2: Plug in the Electrical

Connecting the unit's power transformer to an appropriate electrical outlet.

Step 3: Set the Time of Day

Programming the unit's digital valve with the current time.

All Units - Backwashing and Flushing the System

Step 4-A: Backwash Procedure

Executing the initial backwash cycle to remove media dust.

Step 4-B: Settling Procedure

The settling phase after backwash, preparing for the next step.

All Units - Final Start-Up Procedures

Step 4-C: Rapid Rinse Cycle

Performing the final rinse cycle to clear the system.

Step 5: Final Service Position

Placing the unit in service mode after flushing.

Step 6: Pipes and Heater Flush

Adjusting the Backwash Settings

EWS Series Media Replacement: Removal & Replacement Procedures

CWL Series Media Replacement: Removal & Replacement Procedures

System Shut-off and Valve Disconnection

Media Removal and Tank Preparation

Loading New Media and Re-installation

Limited Warranty

EWS Series: Whole Home Filtration & Conditioning

EWS System Overview

EWS Series System Selection Guide