To Next PageTo Next Page
Need help?Do you have a question about the EWS Series and is the answer not in the manual?
General| Brand | EWS |
|---|---|
| Model | Series |
| Category | Water Filtration Systems |
| Language | English |
Identify main water supply, drain access, electrical outlet, and clearances.
Verify water pressure does not exceed 65 psi.
Position the tank level on a solid floor with adequate space.
Ensure the valve head is securely tightened to the tank.
Connect water supply and filtered outlet following directional arrows.
Connect the drain line to the unit, ensuring an air gap.
Fill the tank slowly by partially opening the inlet valve.
Connect the unit to a dedicated, unswitched electrical outlet.
Set the current time on the digital valve display.
Perform a proper backwash and flush until water runs clear.
Slowly open the outlet valve and check all plumbing connections.
Flush pipes and water heaters by running water through all faucets.
Check pressure (35-65 PSI) and flow (8-12 GPM) requirements.
Proper installation of bypass valves and drain lines is crucial.
Installation schematics and specifications for 1035, 1054, 1354 units.
Installation schematics and specifications for 1354-HF models.
Installation schematics and specifications for 11/2" models.
Check water supply line, drain access, electrical, and clearances.
Guidelines for selecting the unit's installation location.
Specifications for drain line size and installation.
Pressure and flow requirements, PRV recommendation.
Unboxing, checking the valve, and locating bypass/yoke.
Steps for connecting inlet and outlet plumbing lines.
Instructions for slowly filling the tank with water.
Instructions for partially opening the inlet valve to fill slowly.
Fully open the inlet valve after the tank is filled.
Connect the unit's transformer to an unswitched electrical outlet.
Set the current time on the digital valve display.
Purpose and procedure for backwashing and flushing the system.
