Exabyte EXB-8205 - Page 22

LEDs
● =On
❍=Off
j =Flash
a
Tape Drive State
POST (start) POST (end) Failed POST Ready (no tape loaded) Ready (tape loaded) Normal tape motion High-speed tape motion SCSI bus reset Error Time to Clean
Top
(errors)
●●
fast
j
❍❍❍❍●
slow
j
fast
j
Middle
(SCSI)
b
green
●
irreg.
j
irreg.
j
irreg.
j
irreg.
j
irreg.
j
irreg.
j
irreg.
j
irreg.
j
irreg.
j
Bottom
(motion)
● m
c
❍ ml
slow
j
fast
j
●❍
fast
j
a
Slow flash = 1 flash/second (0.94 Hz).
Fast flash = 4 flashes/second (3.76 Hz).
Irregular flash = variable rate depending on SCSI bus activity. If the
tape drive is not connected to the SCSI bus, the LED will be off.
b
Green_8500 or 8200 format.
Amber_8500c or 8200c format.
c
If a tape is loaded, the bottom LED will flash slow and then fast during
the second part of the power-on self-test.
Table 2 tape drive states indicated by the LEDs
22
EXB-8205 and EXB-8505 (Standard and XL) 302967