Need help?Do you have a question about the eXact 100 and is the answer not in the manual?
General| Brand | X-Rite |
|---|---|
| Measurement Geometry | 45°/0° |
| Spectral Range | 400 - 700 nm |
| Spectral Interval | 10 nm |
| Aperture Size | 4mm, 6mm |
| Interface | USB |
Details output accuracy, frequency, voltage range, impedance, and input characteristics of the voltage calibrators.
Explains the fundamental operation and practical uses of the Type 100 and Type 105 voltage calibrators.
Describes the durable, scratch-resistant, and stain-impervious ceramic coating on the calibrator's front panel.
Details the function of the power switch, output selection, voltage/meter controls, and output jack.
Explains the unknown input jack and the mixed-normal switch for signal comparison and operation modes.
Guides the user on how to calibrate an oscilloscope using the Type 100 voltage calibrator.
Specific instructions for using the Type 105 to compare an unknown signal against the internal calibrator.
Discusses safety features like the 3-wire power cord, power supply input range, and cabinet warmth.
Details the transformer, silicon rectifiers, and the -150V and +175V regulated DC power supplies.
Explains the trigger generator, shaper/amplifier, and bi-stable multivibrator for generating waveforms.
Describes the meter circuit for voltage indication and the chopper circuit for signal comparison.
Covers cooling, cleaning, case removal, tube replacement, power supply checks, and frequency adjustments.
Details setting the variable control and adjusting the meter balance for accurate output.
Provides common troubleshooting steps for issues related to tubes, power supplies, and circuit stages.
Presents measured tube socket voltages for troubleshooting and calibration reference.
Lists components such as capacitors, resistors, fuses, and vacuum tubes required for maintenance and repair.
To Next Page
