Notes to Electrician: One bonding lug for US models (two for
Canadian models) is provided on the external surface. To reduce
the risk of electric shock, connect the local common bonding grid
in the area of the swimming pool, spa, or hot tub to these
terminals with an insulated or bare copper conductor not smaller
than 8 AWG US/6 AWG Canada. IMPORTANT - Reference NEC
codes for all wiring standards including, but not limited to,
grounding, bonding and other general wiring procedures.
Notes To Electrician: A green colored screw is located inside the
wiring compartment, against the back panel. To reduce the risk of
electric shock, this terminal must be connected to the grounding
means provided in the electric supply service panel with a
continuous copper wire equivalent in size to the circuit conductors
supplying the equipment.
IMPORTANT INSTALLATION INFORMATION: Installation
should be done strictly in conformance with all local building
codes, electrical codes and other building and safety laws and
regulations. Failure to properly install this product could result in a
dangerous condition, including but not limited to electrical or
structural hazards. ExcelPool Products disclaims all liability
arising from the installation and the user assumes all risk
associated with the installation.
When using electrical equipment, basic safety precautions
should always be exercised.
To Next Page