20
SAFETY INSTRUCTIONS
• Before powering the speaker system, make sure that the mains power voltage
is not higher than that shown on the rear panel.
• Never use the appliance if the power cable or plug are not in perfect
conditions, avoid excessive bending, pulling or cutting of the power cable.
• To prevent the risk of electric shock, never remove cover (or back) of the
speaker system.
• Do not use solvents such as acetone or alcohol to clean the system, as they
would damage its finish.
• Avoid exposing the system to the action of atmospheric agents for a long time
(dampness, excessive heat, strong temperature variations, etc.)
• Clean the system once in a while to avoid excessive dust, when possible protect
the system inside its original packaging for any transport purpose.
WARNING
• To avoid any annoying feedback or noise (larsen effect), make sure that the
microphone cables are screened and that microphones are never pointed in the
direction of the loudspeakers.
CARACTERISTIQUES
• Enclosure adopted a high impact polymer, injection molded shaping. It has high
intensity and light weight, set a handle easy to carry it. Designed non-symetrical
enclosure outline. It can be used for a fold-back speaker.
• Woofer speaker make a high powered pro-speaker. It has wide-range, low
distorsion, high sensitivity, adopted an aluminium frame. It has non-mechanical
resonance.
• Driver selected a titanium diaphragm, and light mass voice coil, make it high
frequency reached 18,000 Hz.
• The new A.A.S.S (automatic amplitude servo system) processor ensures total
protection of the transducers and improvement of the acoustic response.
To Next Page
Loading...