To Next PageTo Next Page
Need help?Do you have a question about the Exlar GSX Series and is the answer not in the manual?
Details warranty terms, limitations, and seller's liability.
Outlines critical safety precautions for installation and operation.
Overview of GS/X Series actuator system setup and capabilities.
Details on actuator connector pin assignments and wiring.
Information on resolver and encoder feedback devices used in actuators.
Guidelines for routing actuator cables to prevent contamination.
Explains the function and types of the internal holding brake.
Details on external limit switch options for travel sensing.
Information on brake option case extensions and stroke reductions.
Describes the anti-rotation option for maintaining linear motion.
Explains the IP rating system for environmental protection.
Specifies requirements for grease or oil lubrication for actuator longevity.
Details recommended grease type and application for actuators.
Information on oil lubrication for high-performance applications and cooling.
Describes various mounting options available for GS/X Series actuators.
Guidelines for proper mounting to prevent misalignment and ensure performance.
Explains the basic operating principles of the GS/X Series linear actuators.
Step-by-step guide for operating the manual drive feature.
Procedures for safely taking apart the actuator for service.
Guidelines for inspecting and renewing grease for bearing and roller screw.
Steps for correctly putting the actuator back together after maintenance.
Recommendations for replacing main rod seal and bushing during maintenance.
Process for initiating and handling product returns for evaluation or repair.
Introduction to the strain gage load cell option for force measurement.
How to operate and interpret readings from the force measuring option.
Technical specifications and calibration details for the force measuring option.
Wiring information for the load cell connector.
Wiring diagram for the terminal box used in Class I Division 2 applications.
Instructions for connecting wires using spring clamp terminals.
Dimensional information for terminal boxes used in Class I Division 2 options.
Details UL certification for the product, including standards and scope.
EU conformity declaration for Exlar products, listing applicable directives and standards.
Details CSA certification for the product, including applicable standards and conditions.
General| Brand | Exlar |
|---|---|
| Model | GSX Series |
| Category | Controller |
| Language | English |
