If Grill Still Fails To Light
1. Check gas supply and connections for leaks.
Check that all wire connections are secure.
2. Repeat basic lighting procedure. If your grill still
fails to operate, turn the gas off at source, turn the
control knobs to OFF, then check the following:
• Misalignment of burner tubes over orifices
Correction: Reposition burner tubes over orifices.
• Obstruction in gas line
Correction: Remove fuel line from grill. Do not smoke!
Open gas supply for 1 second to clear any obstruction
from fuel line. Close off gas supply at source and
reconnect fuel line to grill.
• Plugged orifice
Correction: Remove burners from grill, carefully lift
each burner up and away from gas valve orifice.
Remove the orifice from gas valve and gently clear
any obstruction with a fine wire. Then reinstall all
orifices, burners, and cooking components.
3. If an obstruction is suspected in gas valves, please
call for repair service at 855-256-2160.
4. If the grill still does not light, you may need to purge
air from the gas line or reset the regulator excess gas
flow device. Note: This procedure should be done
every time a new LP gas cylinder is connected to your
grill.
To purge air from your gas line and/or reset the
regulator excess gas flow device:
• Turn the control knob to OFF position.
• Turn off the gas at the cylinder valve.
• Disconnect regulator from LP gas cylinder.
• Let unit stand for 5 minutes.
• Reconnect regulator to the LP gas cylinder.
• Turn the cylinder valve on slowly until ¼ to ½ open.
• Open the grill hood.
• Set control knobs to OFF. Push and turn any control
knob to MAX.
• Turn control knobs to MAX until all the burners are lit
• You may start to use the grill.
5. If all checks or corrections have been made and
you still have questions about operating your gas grill,
call the Customer Service Helpline 8 AM – 4:30 PM
Eastern Time, Monday to Friday at 855-256-2160.
Manually Lighting Your Grill by Match
1. Take the manual lighting stick.
2. Insert a match into the lighting stick.
3. Follow steps 1 through 6 of the Basic Lighting
Procedure.
4. Light the match, and then extend the ignition
rod to the burner surface.
5. Turn the desired control knob to the MAX to
release gas. The burner should light
immediately.
22
WARNING
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and
body a safe distance (at least 18 inches)
from the cooking grid surface when lighting
your grill by match.
WARNING
Should a “FLASH-BACK” fire occur in/or
around the burner tubes, follow the instructions
below. Failure to comply with these instructions
could result in a fire or explosion that could
cause serious bodily injury, death, or property
damage.
• Shut off gas supply to the gas grill.
• Turn the control knobs to OFF position.
• Put out any flame with a proper fire
extinguisher.
• Open grill hood.
• Once the grill has cooled down, clean the
burner tubes and burners according to the
cleaning instructions found on page 24.
To Next Page
Loading...