Exploranium KT-9 - Power on or off

12
Power
ON
or
OFF
5
Attach new battery to connector (the design of the con-
nector allows only the correct orientation).
6
Insert the new battery into the cavity, ensuring that the
fabric pull tab is behind the battery (for easy removal next
time).
7
Replace the cover.
8
Insert and tighten the screw.
Power
ON
or
OFF
The
R
IGHT
and
L
EFT
buttons are used to turn the KT-9
O
N
or
O
FF
.
Power
ON
1
Press the
R
IGHT
button.
When the KT-9 powers on, the following test display is shown
for about a second:
After this the display will change to last mode that was used.
This convenience allows you to immediately continue opera-
tions where you left off.
If you are going to store your KT-9 for a longer term (over
thirty days), please remove the battery from the unit to pre-
vent damage from electrolyte leakage. It is also recom-
mended that you visually inspect the battery after any long
storage interval.
18:888
LoBAT
12
Power
ON
or
OFF
5
Attach new battery to connector (the design of the con-
nector allows only the correct orientation).
6
Insert the new battery into the cavity, ensuring that the
fabric pull tab is behind the battery (for easy removal next
time).
7
Replace the cover.
8
Insert and tighten the screw.
Power
ON
or
OFF
The
R
IGHT
and
L
EFT
buttons are used to turn the KT-9
O
N
or
O
FF
.
Power
ON
1
Press the
R
IGHT
button.
When the KT-9 powers on, the following test display is shown
for about a second:
After this the display will change to last mode that was used.
This convenience allows you to immediately continue opera-
tions where you left off.
If you are going to store your KT-9 for a longer term (over
thirty days), please remove the battery from the unit to pre-
vent damage from electrolyte leakage. It is also recom-
mended that you visually inspect the battery after any long
storage interval.
18:888
LoBAT