Exploranium KT-9 - Configuring for Right or Left-Handed Use

15
Configuring for right or left-handed use
To make the KT-9 fully adaptable to your way of working in the
field, it can be set to operate in either a right or left-handed
mode. This means that the main measurement functions, i.e.
the button you would press most often, can be re-mapped to be
activated on either the right or left side of the KT-9.
Whenever a re-mappable button is referred to in the following
documentation, it will be described from a right-handed opera-
tions point of view, unless specified otherwise. The special icons
shown in the margins will be used to highlight a right or left re-
mapped button respectively.
To change from right to left-handed usage:
1
The display in the measurement mode will have a r: as the
first character, e.g.
2
Press the
L
EFT
button twice to get to the C: menu. Please
also refer to Figure 4 on page 14 to see the flow of events.
3
Press the
R
IGHT
button once to toggle to the left-handed
mode. You should now see the following display:
4
Press the
L
EFT
button again to get back to the measure-
ment mode.
To change from left to right-handed usage:
The steps in the previous description need to be repeated,
except that you will be pressing the opposite button.
r:nP
C: LH
15
Configuring for right or left-handed use
To make the KT-9 fully adaptable to your way of working in the
field, it can be set to operate in either a right or left-handed
mode. This means that the main measurement functions, i.e.
the button you would press most often, can be re-mapped to be
activated on either the right or left side of the KT-9.
Whenever a re-mappable button is referred to in the following
documentation, it will be described from a right-handed opera-
tions point of view, unless specified otherwise. The special icons
shown in the margins will be used to highlight a right or left re-
mapped button respectively.
To change from right to left-handed usage:
1
The display in the measurement mode will have a r: as the
first character, e.g.
2
Press the
L
EFT
button twice to get to the C: menu. Please
also refer to Figure 4 on page 14 to see the flow of events.
3
Press the
R
IGHT
button once to toggle to the left-handed
mode. You should now see the following display:
4
Press the
L
EFT
button again to get back to the measure-
ment mode.
To change from left to right-handed usage:
The steps in the previous description need to be repeated,
except that you will be pressing the opposite button.
r:nP
C: LH