Exploranium KT-9 - Page 45

Automatic averaging
37
Automatic averaging
Please refer to Figure 10 on page 36 to see where the averaging
operation takes place.
1
If you hold the L
EFT
button for 1 second, it will trigger the
averaging operation and display the average of all the
values in memory, e.g.
2
Alternatively, if you are scrolling down through the stack
of stored readings, after the first stored reading has been
displayed, pressing the L
EFT
button one more time will also
display the average of all the values in memory.
3
Pressing the
R
IGHT
button returns you to the measurement
mode without clearing the memory stack.
Clearing the memory
Please refer to Figure 10 on page 36 to see where the clearing
operation takes place.
1
After obtaining the average of the readings stored in
memory, i.e. the display is in
o:
mode, pressing the L
EFT
button one more time will clear the memory.
o:12.7
Automatic averaging
37
Automatic averaging
Please refer to Figure 10 on page 36 to see where the averaging
operation takes place.
1
If you hold the L
EFT
button for 1 second, it will trigger the
averaging operation and display the average of all the
values in memory, e.g.
2
Alternatively, if you are scrolling down through the stack
of stored readings, after the first stored reading has been
displayed, pressing the L
EFT
button one more time will also
display the average of all the values in memory.
3
Pressing the
R
IGHT
button returns you to the measurement
mode without clearing the memory stack.
Clearing the memory
Please refer to Figure 10 on page 36 to see where the clearing
operation takes place.
1
After obtaining the average of the readings stored in
memory, i.e. the display is in
o:
mode, pressing the L
EFT
button one more time will clear the memory.
o:12.7