Exploranium KT-9 - Page 70

62
SCAN
7—remote control & data storage
j)
You should then see:
DISPLAY OF KT-9 MUST BE ‘C 0’
PRESS ‘R’ ON PC TO START SCAN MODE >>
You now have 10 seconds to begin the scan, otherwise
the computer will time out and display:
End of 10 sec TIMEOUT
You will then be presented with the clear prompt and
have to start again:
Press “C” ON PC TO CLEAR >>
Figure 17
S
CAN7
showing a time-out after a free-space
measurement
k)
Place the sensor against the object to be scanned.
l)
Press the
r
key to begin scanning.
m)
If everything is
OK
, the KT-9 should be beeping with
the display showing:
n)
As you scan along your sample, the PC display will be
showing each reading as it comes in:
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement
PRESS ’C’ ON PC TO CLEAR >> C
DISPLAY OF KT-9 MUST BE ’C 0’
PRESS ’R’ ON PC TO START SCAN MODE >>
End of 10 sec TIMEOUT
PRESS ’C’ ON PC TO CLEAR >>
5:000
62
SCAN
7—remote control & data storage
j)
You should then see:
DISPLAY OF KT-9 MUST BE ‘C 0’
PRESS ‘R’ ON PC TO START SCAN MODE >>
You now have 10 seconds to begin the scan, otherwise
the computer will time out and display:
End of 10 sec TIMEOUT
You will then be presented with the clear prompt and
have to start again:
Press “C” ON PC TO CLEAR >>
Figure 17
S
CAN7
showing a time-out after a free-space
measurement
k)
Place the sensor against the object to be scanned.
l)
Press the
r
key to begin scanning.
m)
If everything is
OK
, the KT-9 should be beeping with
the display showing:
n)
As you scan along your sample, the PC display will be
showing each reading as it comes in:
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement
PRESS ’C’ ON PC TO CLEAR >> C
DISPLAY OF KT-9 MUST BE ’C 0’
PRESS ’R’ ON PC TO START SCAN MODE >>
End of 10 sec TIMEOUT
PRESS ’C’ ON PC TO CLEAR >>
5:000